#Home depot spray not ozzle full

If clogged, clean with a non sharp object such as a toothpick. Check to make sure your spray tips, spray gun and extension are not clogged. This will loosen the diaphragm and the gun should operate properly. Lightly tap the spray gun on a hard surface. The diaphragm in the spray gun might be sticking. I pump up my Sprayer and nothing comes out through the spray tip.Ī. You will have to use a parts kit listed in our parts area to rebuild your sprayer. Chances are that damage has occurred to one or several of the parts mentioned above. Ok, I have done all the above and my Sprayer still doesn’t build pressure.Ī. Also check for any debris inside of your pump barrel. Make sure there is no nicks, cuts or damage to this piston cup. Then you can slide off your pump barrel and you will see a white piston cup and holder. You will see two slotted ears, press them both in at the same time and remove your pump barrel away from the cap and handle. To remove the pump barrel, look at the top your pump assembly (by the handle). If the above does not remedy your problem, next you will have to check the piston cup. Make sure there is no debris between the check valve and the bottom of the pump barrel. If so, you can remove it by gently pulling it away from the pump tube. Make sure that this is properly inserted into the bottom of the pump assembly. You will see a rubber part on the bottom ( the check valve). Remove the pump assembly and turn upside down. Make sure the pump assembly is screwed on tightly, there is no debris around the gasket on the bottom of the pump barrel, and the spray gun is in a closed position. My Sprayer does not hold or build up pressure.Ī. What do I do? This next section was designed just to answer those questions. I have followed all the instructions and something is wrong. OK ! I have problems and my Sprayer doesn’t work properly. Pump it up a few times and flush out the hose, spraygun and extension.

Make sure you also place the warm soapy water in the tank. The best way is with warm soapy water, make sure after cleaning, you rinse with just warm water. If you don’t, your material may dry in your sprayer and the next time you go to use it, it will not operate properly. Make sure all your connections are tight. Unscrew the nozzle on the end of the spray gun and screw the plastic extension onto the spray gun. Operate the pump by twisting to unlock the handle and pump about 20 times to pressurize your sprayer. Make sure the lid is on tight or else your sprayer will not operate properly.

#Home depot spray not ozzle full

Carefully fill your sprayer to about 1/2 to 3/4 full and place you lid back on your sprayer and turning clockwise. Just remove the lid of the sprayer by turning the handle counter clockwise and removing the pump assembly. On occasion, you may experience an issue or need a replacement part. Your B&G Sprayer is designed to give you years of dependable service.